How can we help you?

How to connect U-Bolt Z-Wave and U-Bolt Pro Z-Wave with Hubitat?

Required hardware:
1. Ultraloq U-Bolt Z-Wave or U-Bolt Pro Z-Wave.

2. Hubitat Hub

Required App:
1. U-tec App.

2. Hubitat App


How to set up?

Step 1. Open U-tec app--U-Bolt Z-Wave--Settings--Z-Wave control. Tap Add to Z-Wave hub.


1635922906_1_.png     1635922937_1_.png


Step 2. Tap Start the Inclusion,  the app will turn to the "Connecting to Z-Wave Hub" page, keep this interface running then open the Hubitat App.

1635922971_1_.png     1635923001_1_.png


Step 3.  Open the Hubitat App, tap Devices, then choose Discover Devices.

1636363226_1_.png     1636363181_1_.png


Step 4. Tap Z-Wave then choose Start Z-Wave Inclusion.

1636363341_1_.png     1636363662_1_.png


Step 5. Choose only Security 2 Class 2-Access control, tap OK, then enter the code. You can find this code on the battery cover. then tap OK.

1636363817_1_.png     1636363922_1_.png  


Step 6. Input a label for your lock, then tap Save. On the settings page, select the Device Type as Generic Z-Wave lock. After that, tap Save Device.

1636364009_1_.png     1636364199_1_.png


Step 7. Open the U-tec app, you will find the status of Z-Wave Control turns to Paired.



Step 8. Open the Hubitat app, you can control and check the lock status now.



How to set disconnect?

Step 1. Open the U-tec app--U-Bolt Z-Wave--Settings--Z-Wave control. Tap Remove from Z-Wave hub.

1635924423_1_.png     1635924481_1_.png  


Step 2. Tap Start the Exclusion, the app will turn to the "Disconnecting from Z-Wave Hub" page.

1636701537_1_.png     1635924605_1_.png


Step 3. After a few seconds, the device will be removed successfully.

1635924671_1_.png     1635924714_1_.png

Was this article helpful?
0 out of 0 found this helpful