This method only works with U-bolt Z-Wave or U-Bolt Pro Z-Wave.
If you have other models that work with a bridge or have built-in WiFi chips, please check
1. Ultraloq U-Bolt Z-Wave or U-Bolt Pro Z-Wave.
2. Samsung Hub
1. U-tec App.
2. Samsung SmartThings App
How to set up?
Step 1. Open the SmartThings App, choose the Devices, then tap the upper-right corner"+" sign.
Step 2. Tap Partner devices, then tap Z-Wave.
Step 3. Open U-tec app--U-Bolt Z-Wave--Settings--Z-Wave control. Tap Add to Z-Wave hub.
Step 4. Tap Start the Inclusion, and the app will show the "Connecting to Z-Wave Hub", keep this interface running then open the SmartThings App.
Step 5. Open the SmartThings app, then tap the Start button then tap Next. During this step, please don't swap the app until the app asks you to scan the QR code or input the PIN code.
Step 6. Scan the QR code or Enter the PIN code. You can find the QR code and pin code on the battery cover. After scanning or entering the code. tap Add Device.
Step 7. Set up success, you can find the new device under the device list.
Step 7. Open the U-tec app, you will find the status of Z-Wave Control turns to Paired.
How to set disconnect?
Step 1. Open the SmartThings app, find the Hub, tap it then tap the upper-right button.
Step 2. Choose Z-Wave utilities, then tap Z-Wave exclusion. Keep the SmartThings app running, then open the U-tec app.
Step 3. Open the U-tec app--U-Bolt Z-Wave--Settings--Z-Wave control. Tap Remove from Z-Wave hub.
Step 4. The app will turn to the "Disconnecting from Z-Wave Hub" page. After a few seconds, the device will be removed successfully.